It is highly recommended that you print this topic so you have it in the event of a system crash.
This topic describes the steps you need to take to re-install this product on the same computer after a system crash or on a different computer. The information below assumes that your computer is in running condition and any system problems have already been resolved.
You will need the following before continuing:
1. Your license information sent to you when you purchased. You were instructed to print this sheet and retain it for future reference when you originally purchased.
2. The installation file for the same major version you purchased. The version you are licensed for is shown with your license information. If you are purchased version 6, your license information will work with 6.1.0.0, 6.2.0.0, etc. but will not work with any other version.
| NOTE: If you need another copy of the install file please visit our website. If you are licensed for the latest version you can download the install file from the main download area. If you are licensed for an older version and do not wish to upgrade to the latest (a small charge applies), then you can download the major version you registered from the Licensed User Page. In all cases you will be downloading the trial version, which you will convert into the full version using your license information after it is installed.
|
|
|
Once you have the install file and your license information you can install the software on your repaired or new computer by running the installation file. Once installed, run the software from the Start Menu or Desktop icon and click the "Enter License Information" link on the introduction screen to enter your license information and activate the full product. Be sure to enter your license information EXACTLY as given to you, following the instructions given to you.
If your license information is not accepted you have the wrong major version (or product) installed. Please see item 2 above.
At this point you should have the software installed and registered on your new or repaired computer. If you have any existing designs you will need to copy them to your new computer. Once the files are available please see Opening an Existing Design